User's Manual

Installation precautions
zNID 24xxA1 Hardware Installation Guide
43
2 Mark the hole positions.
The holes for the fiber tray are 13 cm apart (about 5.12 inches or a little
less than 5 and 1/8 inches) on the horizontal axis.
3 Drill the holes.
4 Attach the screws.
Use screws appropriate for the type of surface to which the unit is
mounted (i.e. wood, brick, CB, etc.).
5 Put the zNID on the screws.
The screws should be leave enough space from being flush with the wall
for the zNID legs to hold the unit firmly against the wall.
Desktop with fiber tray
To mount the zNID fiber tray on a wall:
1 Prepare the surface for mounting.
2 Wind the fiber in the tray.
See Optical fiber cable placement in the zNID fiber tray on page 45
3 Put the zNID on the fiber tray.
The wall mount sockets on the zNID fit the two nubs which stick out from
the fiber spool on the fiber tray.