User's Manual
3 Checking for compatibility (Default Setup: ‘1’)
As telephone manufactures can vary their configuration, it is necessary to have
compatibility selections on the base unit to ensure that the unit is compatible with
virtually any telephone.
To check and adjust for compatibility between the Base unit and the telephone
perform the following:
While wearing the headset – push the ON/OFF button
If you cannot hear a dial tone with the factory setting, switch to the ‘2’ position
of the COMPATIBILITY switch on back of the base unit until you hear a clear
dial tone.
4 Making and ending call using a telephone with LIFTER attached
While wearing the headset, press the ON/OFF button
Check the lifter function activates (telephone connection opens)
You can hear a dial tone
RED LED on the headset unit will be turned off (in-use status) and RED LED
on the Base unit is blinking.
Dial desired number
To end the call press the ON/OFF button on the headset
Check the lifter function de-activates (telephone connection closes)
RED LED on the headset will be blinking every 10 seconds (standard paired
status) and RED LED on the Base turns on.