Installation manual

Pg 32
Zone 9-16 Area Selection
21
Feat.
Pg 31
Zone 9-16 Configuration Groups
20
Feat.
16 16
Area 1 Area 2 Area 3 Area 4 Area 5 Area 6 Area 7 Area 8
2 2 2 2 2 2 2 2 3 3 3 3 3 3 3 3 4 4 4 4 4 4 4 4 6 6 6 6 6 6 6 6 7 7 7 7 7 7 7 7 8 8 8 8 8 8 8 8 1 1 1 1 1 1 1 1 5 5 5 5 5 5 5 5
Segment 1
(Zone 9)
Segment 2
(Zone 10)
Segment 3
(Zone 11)
Segment 4
(Zone 12)
Segment 5
(Zone 13)
Segment 6
(Zone 14)
Segment 7
(Zone 15)
Segment 8
(Zone 16)
16 16 16 16 16 16
Pg 31
Zone 1-8 Area Selection
19
Feat.
Area 1 Area 2 Area 3 Area 4 Area 5 Area 6 Area 7 Area 8
2 2 2 2 2 2 2 2 3 3 3 3 3 3 3 3 4 4 4 4 4 4 4 4 6 6 6 6 6 6 6 6 7 7 7 7 7 7 7 7 8 8 8 8 8 8 8 8 1 1 1 1 1 1 1 1 5 5 5 5 5 5 5 5
Segment 1
(Zone 1)
Segment 2
(Zone 2)
Segment 3
(Zone 3)
Segment 4
(Zone 4)
Segment 5
(Zone 5)
Segment 6
(Zone 6)
Segment 7
(Zone 7)
Segment 8
(Zone 8)
Pg 29
Area 1 - Entry / Exit Timers
17
Feat.
30 30
60 60
Entry Timer #1 Entry Timer #2
Exit Timer #1 Exit Timer #2
Segment 1 Segment 3
Segment 2 Segment 4
Pg 29
Zone 1-8 Configuration Groups
18
Feat.
7 1616161616163
Reserved Reserved
Segment 5 Segment 6
Pg 35
Siren / Communicator Attempt Count
Feat.
23
0
On if Box Tamper report enabled On enable Lost Clock service light
On if Fail To Communicate report enabled Enable Two Wire Smoke
On if Siren Supervision report enabled On will prevent force armed zones to report bypass
On if End Download report enabled Reserved
On if Auxilary Power Over-current report enabled On will enable all Dual End of Line (DEOL) resistors on all zones
On if Start/End programming report enabled Reserved
On if Expander Trouble reporting enabled On will Auto Partial Arm Area 1
On if Expander Module (number) to be reported via the Contact I.D Reserved
On if AC Fail reporting enabled On enables Zone Doubling
On if Log Full report enabled Reserved
On if Telephone Line Cut report enabled On enables Silent Exit option
On if Sensor Low Battery report enabled Disable Clean-Me Reports (not used in Australia)
On if Low Battery reporting enabled On disables all hardwired zones on the NX board
On if Auto-test report enabled Enable Zone Inactivity Time In Hours
Reserved Reserved
On if Sensor Missing report enabled Disable Steady (Temporal) Siren (On enables Evacuation Siren for fire
Segment 3 Segment 5
Segment 4 Segment 6
1
2 2 3 3 4 4 6 6 7 7 7 8 8 5 5 3 3 1 1 2 4 4 6 6 5 5 8 1
On if siren sounds for ‘Telephone Line Cut’ when armed On to enable Voltage Output; Off to enable On-board Siren Driver On if siren blast at closing kiss-off On if Battery Missing Test is performed every 12 seconds On if siren blast at exit delay expiration On if First to Open Last to Close Reports Siren blasts 1x for key-switch / wireless arming; 2x for disarming On if Box Tamper Pins on the control panel are enabled On if siren sounds for ‘Telephone Line Cut’ when disarmed On if sirens should sound on expander trouble On if siren limited to once per zone On if Strobe flashes for 3s for Key-switch Arm and 6s for Disarm On if siren blast at arming On if Communicator limited to once per zone On if siren sounds for a Zone or Box Tamper On if Manual Communicator Test performed during [*]-[44] function
Pg 32
System Options
22
Feat.
Segment 1 Segment 2
1
2 2 3 3 4 4 7 7 5 5 1 6 6 8 8
7 8
Reserved Reserved Reserved Reserved Reserved Reserved Reserved Reserved
Segment 7
1 2 3 4 6 7 8 5
2