Installation manual

© Hills Industries 2009 Page 16
3. Setting The LED Code Pad Number And Area Options - Function [9] [4]
Step 1
Your system must be in the disarmed state to program the code pad settings
Step 2 Press the []-[9]-[4] key
Step 3 Enter the [Program Code] – The ‘Service’ LED will flash
Step 4 Enter the code pad number [1-8]
Step 5 Press [] - The ‘Instant’ LED will illuminate steady and the ‘Service’ LED will remain flashing
Step 6 Enter the [Area Number] for the code pad (the code pad will automatically exit this mode at this time)
4. Set Elapsed Hours Since Last Auto Test - Function [9] [5]
Step 1
Your system must be in the disarmed state to program the code pad settings
Step 2 Press the []-[9]-[5] keys
Step 3 Enter the [Program Code] – The ‘Service’ LED will flash
Step 4
Enter [100's digit] - [10's digit] - [1's digit] for the elapsed hours
Example: if you have programmed the Auto-Test intervals to report every 72 hours, the value in this
function will determine the first time the auto test report is made, so to have the first test occur in 12
hours and then every 72 hours, simply subtract the 12 from 72 which gives you a value of 60 hours. The
value in this function would be [6][0].
Step 5 Press the [#] key to exit this function
5. Set System Date - Function [9] [6]
Step 1 Press the []-[9]-[6] keys
Step 2 Enter the [Master Code]
Step 3
Enter the ‘Day of Week Code’:
1 = Sunday 3 = Tuesday 5 = Thursday 7 = Saturday
2 = Monday 4 = Wednesday 6 = Friday
Step 4
Enter the ‘Month Code’ – this must be two (2) digits:
01 = January 05 = May 09 = September
02 = February 06 = June 10 = October
03 = March 07 = July 11 = November
04 = April 08 = August 12 = December
Step 5
Enter the ‘Day Code’ – this must always be two (2) digits.
Example: The 5th would be entered as [0][5]
Step 6
Enter the last two digits of the ‘Year Code’. Example: For 2006 enter [0][6].
6. Setting The System Clock - Function [9] [7]
Step 1 Press the []-[9]-[7] keys.
Step 2 Enter the [Master Code]
Step 3
Enter the ‘Hour Code’, which must be two (2) digits. Note: The clock is a 24-hour clock.
Example: Enter 12:00 am as [0]-[0], 7.00 AM as [0]-[7], and 5:00 PM as [1]-[7].
Step 4
Enter the ‘Minutes Code’, which must be two (2) digits.
Example: 7 minutes after the hour would be entered [0] [7].