Installation manual

SETTING THE SYSTEM CLOCK - Function [9][7]

Step 1

Press the [r] key .

Step 2 Press the [9]-[7] keys.

Step 3 Enter the “Master Code”.

Step 4 Enter the “hour code” which must be two (2) digits. Note: The clock is a 24 hour clock.

Example: 12.00 am would be entered as [0]-[0], 7.00 AM would be entered as [0]-[7], and 5.00 PM would be entered as [1]-[7].

Step 5 Enter the “minutes code” which must be two (2) digits.

Example: 7 minutes after would be entered [0] [7].

CHANGING USER CODES - Function [5]

Step 1 Your system must be in the Disarmed state to change user codes.

Step 2

Press the [r] key.

Step 3 Press the [5] key.

Step 4 Enter a “Master Arm/Disarm Code”.

NOTE: For multi area systems, someone changing the code of another person must have access to all or more areas than the

user being changed.

Step 5 The ready light will flash.

Step 6 Enter the 2 digit “user number” (always enter 2 digit such as [0]-[3] for user 3, or [5]-[2] for user 52).

Step 7 Enter the new four (4) or six (6) digit “user code”. Note: To delete a user code, enter [Chime]-[Chime]-[Chime]-

[Chime] for a 4-digit code, or [Chime]-[Chime]-[Chime]-[Chime]-[Chime]-[Chime] for a 6-digit code.

Step 8 The ready light will flash indicating you are back at Step 5 above. If the code is rejected, the sounder will beep 3

times.

Step 9 If another “user code” needs to be programmed, return to Step 6

Step 10 Press the [#] key while the ready light is flashing to exit the User Code Programming Mode.

ASSIGNING USER CODE AUTHORITY LEVELS - Function [6]

Step 1 Assign user codes before assigning authority levels.

Press the [*] key.

Step 2 Press the [6] key.

Step 3 Enter a “Master Arm/Disarm Code”.

NOTE: a user changing the authority of another user can only add or remove area authorization for areas to which they have

access.

Step 4 The ready light will flash.

Step 5 Enter the 2 digit “user number” to be assigned authority. (The ready light is constant and the partial light will flash).

Step 6 Lights illuminated indicate the authority levels assigned to this code. An explanation of the lights is listed below. You

may toggle (turn on/off) the authority level by pressing the number for that authority level