Installation manual

SETTING THE LED CODE PAD NUMBER AND AREA OPTIONS- Function [9][4]

Step 1 Your system must be in the Disarmed state to program the code pad settings.

Step 2

Press the [r] key.

Step 3 Press the [9]-[4] key.

Step 4 Enter the [program code]- The "Service" LED will flash.

Step 5 Enter the code pad number (1-8)

Step 6

Press [r]- The "Instant" LED will illuminate steady and the "Service" LED will remain flashing

Step 7 Enter the area number for the code pad (The code pad will automatically exit this mode at this time)

SET ELAPSED HOURS SINCE LAST AUTOTEST - Function [9][5]

Step 1 Your system must be in the Disarmed state to program the code pad settings.

Step 2

Press the [r] key.

Step 3 Press the [9]-[5] key.

Step 4 Enter the [program code]- The "Service" LED will flash.

Step 5 Enter [100's digit] -[10's digit]-[1's digit] for the elapsed hours.

Example, if you have programmed the Auto-Test intervals to report every 72 hours, the value in this function will

determine the first time the autotest report is made, so to have the first test occur in 12 hours and then every 72

hours, simply subtract the 12 from 72 which gives you a value of 60 hours. The value in this function would be [6][0].

Step 6 Press the [#] key to exit this function..

SET SYSTEM DATE - Function [9][6]

Step 1

Press the [r]-[9]-[6].

Step 2 Enter the “Master Code”.

Step 3 Enter the “Day of Week”.

1 = Sunday 3 = Tuesday 5 = Thursday 7 = Saturday

2 = Monday 4 = Wednesday 6 = Friday

Step 4 Enter the “Month Code”. This must always be two (2) digits.

01 = January 05 = May 09 = September

02 = February 06 = June 10 = October

03 = March 07 = July 11 = November

04 = April 08 = August 12 = December

Step 5 Enter the “Day Code”. This must always be two (2) digits.

Example: The 5th would be entered as [0][5].

Step 6 Enter the last two digits of the “Year Code”. Example: For 2000 enter [0][0].