Installation manual

33
FEATURE 55 AREA 7 - ENTRY / EXIT TIMERS
SEGMENTS 1-4
ENTRY TIME 1 - 0 EXIT TIME 1 - 0 ENTRY TIME 2 - 0 EXIT TIME 2 - 0
Feature 55 sets the primary and secondary entry / exit times for area 7. If all segments in this Feature are set to
“0”, the entry / exit time for this area will follow area 1 (Feature 17). Valid entries are 10-255 seconds
FEATURE 56 AREA 8 ACCOUNT CODE
SEGMENTS 1-4
10 10 10 10
Feature 56 contains the account code sent when area 8 is reported. If Feature 56 is left un-programmed (all
“10"s), then the account code corresponding to the Phone number dialed will be used.
FEATURE 57 AREA 8- OPTION AND REPORT SELECTIONS
Feature 57 is used to enable certain options that can be accessed or are visible to the user from the code pad of
the system. In addition, certain communicator reports are enabled in Feature 16. Each of these options can be
enabled by area. If the option selection feature for any area is left blank, that area will use Feature 16 for
the option selection. REFER TO FEATURE 39 IN THIS SECTION FOR OPTIONS TABLE.
FEATURE 58 AREA 8 - ENTRY / EXIT TIMERS
SEGMENTS 1-4
ENTRY TIME 1 - 0 EXIT TIME 1 - 0 ENTRY TIME 2 - 0 EXIT TIME 2 - 0
Feature 58 sets the primary and secondary entry / exit times for area 8. If all segments in this Feature are set to
“0”, the entry / exit time for this area will follow area 1 (Feature 17). Valid entries are 10-255 seconds