Installation manual

32
FEATURE 48 AREA 5 - OPTION AND REPORT SELECTIONS
Feature 48 is used to enable certain options that can be accessed or are visible to the user from the code pad of
the system. In addition, certain communicator reports are enabled in Feature 16. Each of these options can be
enabled by area. If the option selection feature for any area is left blank, that area will use Feature 16 for
the option selection. REFER TO FEATURE 39 IN THIS SECTION FOR OPTIONS TABLE.
FEATURE 49 AREA 5 - ENTRY / EXIT TIMERS
SEGMENTS 1-4
ENTRY TIME 1 - 0 EXIT TIME 1 - 0 ENTRY TIME 2 - 0 EXIT TIME 2 - 0
Feature 49 sets the primary and secondary entry / exit times for area 5. If all segments in this feature are set to
“0”, the entry / exit time for this area will follow area 1 (Feature 17). Valid entries are 10-255 seconds
FEATURE 50 AREA 6 ACCOUNT CODE
SEGMENTS 1-4
10 10 10 10
Feature 50 contains the account code sent when area 6 is reported. If Feature 50 is left un-programmed (all
“10"s), then the system account code (Feature 5) will be used.
FEATURE 51 AREA 6 - OPTION AND REPORT SELECTIONS
Feature 51 is used to enable certain options that can be accessed or are visible to the user from the code pad of
the system. In addition, certain communicator reports are enabled in Feature 16. Each of these options can be
enabled by area. If the option selection feature for any area is left blank, that area will use Feature 16 for
the option selection. REFER TO FEATURE 39 IN THIS SECTION FOR OPTIONS TABLE.
FEATURE 52 AREA 6 - ENTRY / EXIT TIMERS
SEGMENTS 1-4
ENTRY TIME 1 - 0 EXIT TIME 1 - 0 ENTRY TIME 2 - 0 EXIT TIME 2 - 0
Feature 52 sets the primary and secondary entry / exit times for area 6. If all segments in this feature are set to
“0”, the entry / exit time for this area will follow area 1 (Feature 17). Valid entries are 10-255 seconds
FEATURE 53 AREA 7 ACCOUNT CODE
SEGMENTS 1-4
10 10 10 10
Feature 53 contains the account code sent when area 7 is reported. If Feature 53 is left un-programmed (all
“10"s), then the system account code (Feature 5) will be used.
FEATURE 54 AREA 7- OPTION AND REPORT SELECTIONS
Feature 54 is used to enable certain options that can be accessed or are visible to the user from the code pad of
the system. In addition, certain communicator reports are enabled in Feature 16. Each of these options can be
enabled by area. If the option selection feature for any area is left blank, that area will use Feature 16 for
the option selection. REFER TO FEATURE 39 IN THIS SECTION FOR OPTIONS TABLE.