Installation manual

FEATURE 41 AREA 3 ACCOUNT CODE

SEGMENTS 1-4

10 10 10 10

Feature 41 contains the account code sent when area 3 is reported. If Feature 41 is left un-programmed (all

“10"s), then the system account code (Feature 5) will be used.

FEATURE 42 AREA 3 - OPTION AND REPORT SELECTIONS

Feature 42 is used to enable certain options that can be accessed or are visible to the user from the code pad of

the system. In addition, certain communicator reports are enabled in Feature 16. Each of these options can be

enabled by area. If the option selection feature for any area is left blank, that area will use feature 16 for

the option selection. REFER TO FEATURE 39 IN THIS SECTION FOR OPTIONS TABLE.

FEATURE 43 AREA 3 - ENTRY / EXIT TIMERS

SEGMENTS 1-4

ENTRY TIME 1 - 0 EXIT TIME 1 - 0 ENTRY TIME 2 - 0 EXIT TIME 2 - 0

Feature 43 sets the primary and secondary entry / exit times for area 3. If all segments in this feature are set to

“0”, the entry / exit time for this area will follow area 1 (Feature 17). Valid entries are 10-255 seconds

FEATURE 44 AREA 4 ACCOUNT CODE

SEGMENTS 1-4

10 10 10 10

Feature 44 contains the account code sent when area 4 is reported. If Feature 44 is left un-programmed (all

“10"s), then the system account code (Feature 5) will be used.

FEATURE 45 AREA 4 - OPTION AND REPORT SELECTIONS

Feature 45 is used to enable certain options that can be accessed or are visible to the user from the code pad of

the system. In addition, certain communicator reports are enabled in Feature 16. Each of these options can be

enabled by area. If the option selection feature for any area is left blank, that area will use Feature 16 for

the option selection. REFER TO FEATURE 39 IN THIS SECTION FOR OPTIONS TABLE.

FEATURE 46 AREA 4 - ENTRY / EXIT TIMERS

SEGMENTS 1-4

ENTRY TIME 1 - 0 EXIT TIME 1 - 0 ENTRY TIME 2 - 0 EXIT TIME 2 - 0

Feature 46 sets the primary and secondary entry / exit times for area 4. If all segments in this feature are set to

“0”, the entry / exit time for this area will follow area 1 (Feature 17). Valid entries are 10-255 seconds

FEATURE 47 AREA 5 ACCOUNT CODE

SEGMENTS 1-4

10 10 10 10

Feature 47 contains the account code sent when area 5 is reported. If Feature 47 is left un-programmed (all

“10"s), then the system account code (Feature 5) will be used.