Installation manual
30
FEATURE 37 AREA 1 ACCOUNT CODE
SEGMENTS 1-4
10 10 10 10
Feature 37 contains the account code sent when area 1 is reported. If Feature 37 is left un-programmed (all
“10"s), then the system account code (Feature 5) will be used.
FEATURE 38 AREA 2 ACCOUNT CODE
SEGMENTS 1-4
10 10 10 10
Feature 38 contains the account code sent when area 2 is reported. If Feature 38 is left un-programmed (all
“10"s), then the system account code (Feature 5) will be used.
FEATURE 39 AREA 2 - OPTION AND REPORT SELECTIONS
Feature 39 is used to enable certain options that can be accessed or are visible to the user from the code pad of
the system. In addition, certain communicator reports are enabled in Feature 16. Each of these options can be
enabled by area. If the option selection feature for any area is left blank, that area will use feature 16 for
the option selection.
SEGMENT 1
1
On enables the Quick Arm option
2
On enables the Re-exit option
3
On enables the Force Arm option
4
On enables the Silent Code Pad Panic option
5
On enables the Audible Code Pad Panic option
6
On enables the Code Pad Fire option
7
On enables the Code Pad Medical option
8
On enables the Code Pad Multiple Code Attempt Tamper option
SEGMENT 2
1
On enables the LED Extinguish option.
2
On enables the Require Code for Bypassing option
3
On enables the Zone Bypassed Sounder Alert option
4
On enables the AC Power/Low Battery Sounder Alert option
5
On enables Bypass toggle
6
On enables Silent Auto Arm
7
On enables the Universal Arming option
8
On enables the One Key Partial Mode Disarm
SEGMENT 3
1
On enables Opening and Closing reports
2
On enables Zone Bypass reporting
3
On enables Zone Restore reporting
4
On enables Zone Trouble reporting
5
On enables Zone Tamper reporting
6
On enables the Cancel option
7
On enables Recent Closing option
8
On enables Exit Error option
FEATURE 40 AREA 2 - ENTRY / EXIT TIMERS
SEGMENTS 1-4
ENTRY TIME 1 - 0 EXIT TIME 1 - 0 ENTRY TIME 2 - 0 EXIT TIME 2 - 0
Feature 40 sets the primary and secondary entry / exit times for area 2. If all segments in this feature are set to
“0”, the entry / exit time for this area will follow area 1 (Feature 17). Valid entries are 10-255 seconds