Installation manual

29
FEATURE 32 AUTO-TEST CONTROL
SEGMENTS 1-4
7 168
03 00
SEGMENT 1
Program a 0" if the intervals are in hours. “1 - 8" if in days.
1 = SUN, 2=MON, 3=TUE, 4=WED, 5=THU, 6=FRI 7 = SAT and 8 = DAILY
SEGMENT 2 Program the Auto-test hourly interval from 1-255 hours
SEGMENT 3
Program the Auto-test report hour in 24 hour format (if segment 1 is set to hourly intervals, this segment
is ignored)
SEGMENT 4 Program the Auto-test report time, number of minutes after the hour
FEATURE 33 OPENING TIME
SEGMENTS 1-2
HOURS - 06 MINUTES - 00
Feature 33 contains the time (in 24 hour format) the NX-16 enables codes designated as “Arm Only after Closing”. This time is
only valid on those days programmed in Feature 35. Note: Opening time must be earlier than closing time for Aux.
Outputs, or Code Authorization to function properly.
FEATURE 34 CLOSING TIME / AUTO ARMING TIME
SEGMENTS 1-2
HOURS - 20 MINUTES - 00
Feature 34 contains the time in 24 hour format the NX-16 disables the disarm capability for codes designated as arm only after
closing. This is also the Automatic Arming time. If enabled in Feature 36 NX-16 will Auto Arm the specified area(s). At this time,
the Code Pad will beep for 50 seconds before the panel arms. The arming process can be stopped by entering a valid code on
the Code Pad. Note: Opening time must be earlier than closing time for Aux. Outputs, or Code Authorization to
function properly.
FEATURE 35 “ARM ONLY AFTER CLOSE” WINDOW
Feature 35 selects which days of the week each area is open. On these days, “arm only after close window  codes will be
able to arm and disarm during open window. On days not selected here, “arm only after close window  codes will not disarm.
Segment 1 is for area 1, and segment 8 is for area 8. (See Features 33 and 34 for the opening and closing times for the open
days.
SEGMENTS 1 – 8
AREAS 1 - 8
1 "Arm only after close window" will arm/disarm on Sunday
2 "Arm only after close window" will arm/disarm on Monday
3 "Arm only after close window" will arm/disarm on Tuesday
4 "Arm only after close window" will arm/disarm on Wednesday
5 "Arm only after close window" will arm/disarm on Thursday
6 "Arm only after close window" will arm/disarm on Friday
7
"Arm only after close window" will arm/disarm on Saturday
8 RESERVED
FEATURE 36 DAYS OF THE WEEK FOR AUTO ARMING IN AREAS 1 - 8
Feature 36 selects which days each area will auto arm. Segment 1 is for area 1, and segment 8 is for area 8. If a zone is
faulted when the panel tries to auto arm, the zone will be bypassed.
SEGMENTS 1 – 8
AREAS 1 - 8
1
Auto Arming on Sunday.
2 Auto Arming on Monday
3 Auto Arming on Tuesday
4 Auto Arming on Wednesday
5 Auto Arming on Thursday
6 Auto Arming on Friday
7
Auto Arming on Saturday
8 RESERVED