Installation manual

SYSTEM OPTIONS TABLE

First To Open / Last To Close

If enabled, the NX-16 will only send a closing report when the last area is armed. NOTE: the last area to arm must have

open/close reports enabled. The NX-16 will only send an opening report when the first area is disarmed. NOTE: The first area

to disarm must have open/close reports enabled.

Force Arm Bypass Reports

If enabled, the NX-16 restricts bypass reports when zones are forced armed. Otherwise, when a zone is forced armed (and

bypass reports are enabled), bypass reports are sent at the end of exit time. If forced armed zones re-seal during the armed

period, bypass restores are sent.

Limited Sirens / Communicator

If enabled, the NX-16 will only set one siren activation per zone and/or one alarm report per zone. This option must be disabled

if the siren and communicator attempt counter option is used. If limited communicator is enabled, restore reports (if enabled)

will be sent at disarm, otherwise restore reports will be sent as they occur.

Lost Clock

If enabled, the NX-16 will illuminate the service LED whenever the internal clock is interrupted.

On-Board Zone Disable

If enabled, the NX-16 can disable the 8 on-board zone. This is used when the NX-16 is used as a totally wireless system.

Radio Remote Arm

If enabled, the NX-16 will activate the sirens every time the system is armed or disarmed with a key-switch zone or integrated

wireless keyfob. The sirens will chirp once for arming and twice for disarming. The strobe will flash for 3 seconds for arming

and 6 seconds for disarming.

Silent Exit Option

The exit delay can be silenced by pressing [r]-[Exit] before arming the control panel, or when using the re-exit option. The exit

delay can also be silenced permanently in all partitions.

Tamper Siren

If enabled, all zone tampers and module tampers will set the system sirens.

Telephone Line Cut Siren

If enabled, it will set the siren for the siren time when ever the phone line monitor is activated. The phone line siren can be

reset to be the entry of a valid code. The options set phone line cut sirens in either armed and or disarmed mode. In a multi-

area system, “a system armed state” would be represented by any area that is armed.

Voltage Output

If enabled, the on-board siren output will become a 1 AMP 12V DC output to drive 12V sirens.

Zone Doubling

If enabled, the 8 on-board zones will be doubled to 16 zones. Zone 1 will represent zones 1 and 9, and zone 8 will represent

zone 8 and 16. This option cannot be selected for zones other than the 8 zones on the main panel. This option cannot be used

in conjunction with the DEOL option. To disable this option, first de-select it, and then power down the system.