Installation manual

16
FEATURE 8 PHONE NUMBER THREE (3)
SEGMENTS 1-20
14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14
The third telephone number is programmed in Feature 8. A "14" indicates the end of the phone number. Delays of
four seconds can be programmed at any point in the phone number by programming a "13" in the appropriate
segment. If pulse dialing is desired, program a "15" in the segment where pulse dialing should begin. Program an
“11" for a “r” and a “12" for a “#”.
FEATURE 9 EVENT REPORT SUMMARY
Feature 9 is a summary of event reporting codes found in the Area and System Features. Most Area and System
report event are enabled, but will also need to be enabled in this feature. This approach is used to simplify event
selection programming.
SEGMENT 1
(1)
Alarms
(2)
Restores
3
Open / Close
(4)
Bypass
5
Zone Trouble
(6)
Power Trouble (AC Failure or Low Battery)
7
Tampers
(8)
Test Reports
SEGMENT 2
(1)
System Trouble (siren / phone / expander / short circuit)
(2)
Failure to Communicate
(3)
Sensor Lost / Sensor Low Battery
4
Program, Download, & Full Log (Full Log must also be enabled in system options)
(5)
Cancel Code (Cancel reporting must also be enabled in area options)
6
Recent Closing / Exit Error
7
Reserved
8
Reserved
FEATURE 10 DIAL ATTEMPTS
SEGMENTS 1-2
6 RESERVED
Feature 10, Segment 1 is used to enter the number of dial attempts (1 to 15 Attempts) the communicator will make
to Phone #1 before ending the notification process. Factory default is "6" and the communicator will make 6
attempts to the first number.
FEATURE 11 PHONE LINE CUT DELAY
SEGMENT 1
0
Feature 11 contains the number of second increments in the Telephone line monitor delay before phone line fault
is activated. The Telephone line monitor delay can be programmed in 1 second increments from 1 to 255 seconds.
Note. The NX-16 internal phone line monitoring circuit requires approximately 5 seconds to discharge before the
NX-16 will sense a missing phone line, you must add this time to the value in this feature when testing this option.
A “0” = disabled.