Installation manual

15
FEATURE 4 PHONE NUMBER 0NE (1)
SEGMENTS 1-20
14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14
The first telephone number is programmed in Feature 4. A "14" indicates the end of the phone number. Delays of
four seconds can be programmed at any point in the phone number by programming a "13" in the appropriate
segment. If pulse dialing is desired, program a "15" in the segment where pulse dialing should begin. Program an
“11" for a “r” and a “12" for a “#”.
FEATURE 5 SYSTEM ACCOUNT CODE
SEGMENTS 1-4
10 10 10 10
This is the account code sent for any area event (open/close and zone related alarms) that does not have its
account code programmed. System events (siren / box tampers, expander troubles etc..) will use the system
account unless area one account is programmed.
FEATURE 6 COMMUNICATOR FORMAT
SEGMENT 1
0
Feature 6 contains the communicator format used. Select a format from the format selection table. If this feature
contains a "0", the built-in communicator will be disabled, and the NX-16 will function as a local only control.
FORMAT SELECTION TABLE
DATA FORMAT DESCRIPTION
0 LOCAL
COMMUNICATOR IS DISABLED
1 CONTACT I.D
DTMF FORMAT
2 PAGER
REPORTS IN 4 + 2 DTMF FORMAT. PHONE NUMBERS CAN BE
PROGRAMMED VIA CODE PAD IN THE RUN MODE.
3 DOMESTIC SIREN
DOMESTIC DIALLING VIA A SIREN TONE FORMAT. CALL CAN BE KISSED
OFF VIA THE STAR (*) KEY ON A DTMF PHONE. PHONE NUMBERS CAN
BE PROGRAMMED VIA CODE PAD IN THE RUN MODE.
FEATURE 7 PHONE NUMBER TWO (2)
SEGMENTS 1-20
14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14
The second telephone number is programmed in Feature 7. A "14" indicates the end of the phone number. Delays
of four seconds can be programmed at any point in the phone number by programming a "13" in the appropriate
segment. If pulse dialing is desired, program a "15" in the segment where pulse dialing should begin. Program an
“11" for a “r” and a “12" for a “#”.