Installation manual

14
FEATURE 0 CODE REQUIREMENTS
Feature 0, segment 1 is used to enable the 6 digit user code option. If 6-digit option is enabled, all arm/disarm
codes, the "Go To Program Code" and duress code are 6 digits. If this option is enabled, the default user 1 code
is [1]-[2]-[3]-[4]-[5]-[6]. The NX-16 has 99 four (4) digit user codes or 66 six (6) digit user codes. Segment 2 is used
to enable user code requirement for functions [r]-[9]-[8] (perform call back download) and [r]-[9]-[9] (answer
incoming call for download).
SEGMENT 1
1
On enables the 6-digit code option. Its original off state is a 4-digit code.
2
On requires code entry for [rr]-[9]-[8] and [rr]-[9]-[9] functions
3 –8 RESERVED
FEATURE 1 GO TO PROGRAM CODE
SEGMENTS 1-6
9 7 1 3 0 0
Feature 1 contains the "Go To Program Code". This feature contains either a 4 or 6-digit code. If the 6-digit code
option is enabled in Feature 0, THIS CODE MUST CONTAIN SIX (6) DIGITS. If this option is not enabled in
Feature 0, the last 2 segments (digits) will be ignored. With the NX-16 disarmed, the "Go To Program Code" can
be used to enter the Program Mode.
FEATURE 2 GO TO PROGRAM CODE AREA AND AUTHORISATION
The "Go To Program Code" can be used as a standard arm/disarm code. When using the code to arm or disarm,
the user I.D is 255. (This code may not be changed in the Run Mode.)
SEGMENT 1
1 Reserved.
2
On enables "Go To Program Code" as an arm only code.
3
On enables "Go To Program Code" as an arm only after closing.
(4)
On enables "Go To Program Code" as a master code (can change user codes)
5
On enables "Go To Program Code" as an arm/disarm code.
6
On enables "Go To Program Code" to bypass zones.
7
On enables "Go To Program Code" opening and closing reports.
8 Reserved
SEGMENT 2
(1)
On enables the "Go To Program Code" for Area #1
(2)
On enables the "Go To Program Code" for Area #2
(3)
On enables the "Go To Program Code" for Area #3
(4)
On enables the "Go To Program Code" for Area #4
(5)
On enables the "Go To Program Code" for Area #5
(6)
On enables the "Go To Program Code" for Area #6
(7)
On enables the "Go To Program Code" for Area #7
(8)
On enables the "Go To Program Code" for Area #8
FEATURE 3 DURESS CODE
SEGMENTS 1-6
15 15 15 15 15 15
Feature 3 contains the "Duress" code. This feature contains either 4 or 6 digits. If the 6-digit code option is
enabled in Feature 0, THIS CODE MUST CONTAIN SIX (6) DIGITS. If the 6-digit option is not enabled in Feature
0, the last 2 digits will be ignored. If the duress code is programmed, it will work for all areas.