User manual

To unhook the enclosures we will act on the upper pins of the lower box as indicated below:

First we remove the pins (1) on each side. Now, we reposition the pins in the holders (2). We can now

separate the enclosures (3). Finally, we retract the attachment plates as indicated on the previous page.

AX-VT20

The rigging frame AX-VT20 is suitable for hanging a

maximum of 5 units of VANTEC-20A. It has 11 pick-up points

for the lifting slings, numbered from front to back (see

attached figure). To assure the vertical inclination of the

entire column use the Ease Focus software, which will

indicate which holes have to be used. This frame will be

joined to the first box of the column as if it were another

enclosure and will be locked with safety pins. The other

enclosures will be joined below it as indicated.

IMPORTANT SAFETY WARNING

Maximum number with AX-VT20:

5 VANTEC-20A-----0 VANTEC-118A

4 VANTEC-20A-----2 VANTEC-118A

3 VANTEC-20A-----3 VANTEC-118A

2 VANTEC-20A-----3 VANTEC-118A

1 VANTEC-20A-----4 VANTEC-118A

0 VANTEC-20A-----4 VANTEC-118A

Manual del Usuario / vantec series / User’s Manual

AX-VT20

nº1

nº11