User manual

Please follow the process to attach one box to

another. First, let's look at the sides of the

enclosure that we can see in the figure.

In the figure we can see the safety pin and the

lower trigger. The safety pin is housed in a holder

and the sliding attachment plate is hidden. By

placing the pin in the indicated hole, the enclosure

can be joined with the box directly above by

passing the pin through the orifice in the sliding

attachment plate of the upper box.

This rigging system is compatible with the

VANTEC-118A, making suspension from the VANTEC-

118A easy.

Moving the lower trigger up (1), releases the sliding attachment plate that will fall by its own weight (2).

When the trigger is released, it will return to its original position and the slide will remain fixed (3).

Similarly, to retract the slide we must act on the trigger as in (1) push the slide up (4), and release the

trigger (3).

To attach enclosures, place a VANTEC-20A enclosure with the attachment plates extended upon another

VANTEC-20A. Next, insert the safety pins in the hole and through the orifice of the attachment plates so that the

boxes are joined. The angle between both enclosures will be 15º.

Attention: Make sure the correct insertion of the safety pin.

Safety pin (Ø 6 mm) that

allows to hook the enclosures

The lower trigger releases

and allows to retract the attachment plates.

Manual del Usuario / vantec series / User’s Manual

15º