User's Guide

Colorful Silicone Earbuds
Make sure the earbuds are properly configured for
high quality music. Be sure to try on various sizes
for maximum comfort and performance.
L (Green) M (Yellow) S (Red)
The headphone cable should
be facing the front downward
position.
Turn the ear hooks until they
are pressed against your auricle.
Make sure the ear hooks and
earbuds are comfortably rested
for maximum performance.
Ear hook hanging
Fixed Ear Hooks / Earbuds
Install ear hook onto
area as indicated in the
picture above
Left
Right
daruma Creative Product Warranty
Product name DA-101BT Bluetooth Earbuds
Date of purchase year month day
Phone number 886+2-22999099
Email [e-mail]
daruma Creative Co., Ltd. www.daruma.tw
1.Warranty period: 1 year as of the purchase date
2.Conditions: We provide repair service free of charge but such
service will be limited to normal use only.
Any damage caused by misuse of users shall not be covered
by the warranty hereof.
LED State
Volice “BATTERY LOW”
LED Indicator status
Red light: Charging
Flashing red/blue: pairing mode
Light is off: Standby / power of
f / Battery Full
Flashing red: Low Battery 10 second flashing 3 times
Lift up the raised rubber on
the side of the controller to
charge device with micro USB
charger.
A full 2 hour charge powers
the earbuds for 10 hours of
play time.
There is about 10 minutes left of play time.
Micro USB Charger
Pairing mode
Double Press to switch
Pairing mode
LED red/blue indicator flashes alternately
Voice
:
Double Press to pair your device. After
the voice prompt “Pairing”.
Select DA-101BT on your mobile device
to finalize pairing.After the voice
prompt “Paired”, is
completed.
DA-101BT
Connection
connected
Pairing device
Bluetooth Search
Apple / Android Setting Bluetooth
DA-101BT
Turn on your phone or tablet Bluetooth mode, press and hold the middle button of the control box
for 4 seconds to enter search. Then click on DA-101BT Bluetooth on your device.
Pairing is completed when the symbol changes to
1
3
4
Specification
Mode Type
Bluetooth Version
Impedance
Speaker Sensitivity
THD
Frequency Response
Wireless range
Drive Size
Cord length
Weight
Capacity
Charging Time
Standby Time
Play Time
Waterproof
DA-101BT
V4.0
32 Ohm
103 dB SPL / 1mW @1kHz
<0.1% / 1 kHz / 100 db SPL
20Hz- 20kHz
10 meters (32 inches)
10mm mylar / dynamic magnet
500mm
19g(include wings & buds )
120 mAh
2 Hrs
100 Hrs
10 Hrs
IP54
User Guide
Earbuds
Earhooks Charging Cable
Guide / Warranty Card
L X 2 M X 2 S X 2
L X 2M X 2S X 2
Operation Guide
Click to play / pause
Turn up
Turn down
Long press for more than 3 seconds to turn on/off (answer/hang up)
Double press in off state to pair device (It will automatic when
first turn on)
Next
Previous
Pair
Power
on/off
In-call Operation
Mute call
Unmute
OFF
Switch the call to
DA-101BT
pairing
ON
LMS
The controller box is on the right earphone line.
Please Online registration www.daruma.tw
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one of the following measures:
. Reorient or relocate the receiving antenna.
. Increase the separation between the equipment and receiver.
. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
. Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.
(Example - use only shielded interface cables when connecting to computer or peripheral devices).
FCC Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
This device may not cause harmful interference, and
This device must accept any interference received, including interference that may cause undesired operation.