User's Manual
Table Of Contents
- Multiple Power-Saving Modes ‧The mouse can be manually set to sleep mode by simultaneously pressing all three buttons (both the Left and Right mouse buttons and the Scroll Wheel button at the same time). Press any mouse button to resume normal mouse operation. ‧This mouse will go into an automatic sleep mode after it has not been used for a period of time. Also press any button to go back to its working mode. ‧When the wireless USB mini receiver is stored in the smart receiver storage compartment, the mouse will go into an automatic sleep mode. ‧Simply power off the power switch on mouse bottom. ‧This mouse will go into an automatic sleep mode whenever the signal link with the wireless USB mini receiver is lost, or whenever it is unplugged.
- FCC Statement
- Warning!
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by on or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Warning!
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment.
This equipment nust not be co-located or operating in conjunction with any other antenna
or transmitter.