User's Manual
Table Of Contents
- Introduction
- Identifying headphone components
- Charging the headphones and Bluetooth adapter (select models only)
- Using the headphones with the audio line-in cable
- Using the headphones with the enclosed Bluetooth adapter (provided with select models only)
- Using the headphones with a Bluetooth-enabled computer
- Terminating the headphone wireless connection
- Index
3 Charging the headphones and
Bluetooth adapter (select models only)
Before you can use the headphones with the provided Bluetooth adapter (select models only), you must
charge both the headphones and the Bluetooth adapter. The headphones can be charged from the USB
port on your computer or the provided AC adapter ( select models only).
To charge the headphones, complete the following steps:
CAUTION: When removing the USB charging cable from a device, prevent damage to cable
connectors by grasping each connector and then pulling gently. Do not pull on the cable to remove it
from the device.
1. Be sure that the Bluetooth switch and the noise cancellation switch are in the off position, with no
red indicator visible at the open end of the switch.
2. Plug one of the two Mini-USB connectors into the Mini-USB port on the headphones (1).
The charging light (2) will turn on while the headphones are charging.
3. Plug the other Mini-USB connector into the Mini-USB port on the Bluetooth adapter (3).
The Bluetooth light (4) will turn on while the adapter is charging.
8 Chapter 3 Charging the headphones and Bluetooth adapter (select models only) ENWW
Antenna House XSL Formatter (Evaluation) http://www.antennahouse.com/