Product Manual

23
the chuck securely, remove from
alignment port.
4. Measure the amount of drill protruding
from the end of the chuck to the tip of the
drill.
5. The length of the drill protruding from the
top of the chuck should measure .970-.980
(24.63 mm - 24.89 mm)
Calibrating the Material
removal knob
1. At the rear of
the machine
base there is a
small access
hole.
2. Insert a 3/16
Allen wrench
into the
access hole.
3. To advance
the pusher
shaft cap,
reducing the amount of drill stick out,
rotate the wrench clockwise.
4. To retract the pusher shaft cap, increasing
the amount of drill stick out, rotate the
wrench counterclockwise.
Each ¼ turn will adjust .010 (.25 mm) or one
full turn will adjust .04 (1.0 mm) After adjusting
the pusher shaft assembly, realign the drill and
re-measure the amount of stick out. Repeat the
steps 1-4 until the drill protrudes .970-.980 in
length. (24.63 mm - 24.89 mm)
Wheel Information