Instructions User guide

64
Wheel Change Reminder
• This re-
minder will
prompt you
to change
the wheel
as you se-
lect differ-
ent drill ma-
terial op-
tions.
The XPS-16 does not know what type
of wheel you have mounted; you
must mount a CBN wheel for HSS or
Cobalt drills and a Diamond wheel for Car-
bide drills. Failure to comply will damage or
shorten the life of your grinding wheel.
Door Open error
• Machine door must be closed when “Cycle
Start” button is pressed. After closing
door, push cycle start to continue grind-
ing.
Z AXIS ALARM
• Z axis has moved past
the limit switch. Refer to
page 69 for details.
• Z axis sensor has failed.
C AXIS ALARM
• C axis sensor has failed.
A AXIS ALARM
• A axis has moved past
the limit switch.
• A axis sensor has failed.
X AXIS ALARM
• X axis has moved past
the limit switch. Call Darex
• X axis sensor has failed.
• May be caused by stopping
or powering down during the
lube cycle. See page 69.
BAD CODE ERROR
• Bad controller code
stored in memory.
• XPS-16 waited too
long before receiving a
response from the com-
puter.
Trouble Shooting—XPS-16
Symptom
Machine won’t power up
Cause
• Make sure power cord is plugged in to ma-
chine and outlet
• Release E-stop button
• E-stop nut is loose and stuck down in the
off position
• On/Off switch need replaced
• Wiring lead disconnected
Symptom
After powering up, Initialization screen
does not come up
Cause
• RS232 cable is disconnected
Trouble Shooting Section
• No power at outlet