Instructions User guide

6
CAUTION
Do not operate machine without using vacuum system
Grinding dust inhaled/ingested can be harmful to your health
Grinding particles can cause damage or erratic operation of the sharpener
Airflow from vacuum cools the grinding wheel & motor during sharpening
Do not alter length of vacuum hose
Remove wheel before cleaning
Do not operate machine in adverse environmental conditions
Minimum 7°C (45°F) Maximum 32°C (90°F)
Do not remove jaws from springs OR springs from
spindle insert
Jaws are positioned and then match ground. By disassembling you will compromise the concentric-
ity. Refer to information on page 47
Do not interrupt or shut down sharpening machine while in the
lube cycle
Remove drill from chuck before pressing the Check icon to continue lube process
Do not interrupt or shut down sharpening machine while
downloading software
Use a Diamond wheel to grind carbide drills
Grinding carbide on a CBN wheel will cause damage to the wheel
Use grounding straps and static dissipating
materials when handling electronics
Do not pinch, bend or crimp the Fiber optic
ca
ble
The thin black cable, can be found underneath the left side of the top
cover, fastened to the top of the spindle cartridge block
Do not over tighten chuck when securing drill
May cause chuck to lock up
Do not replace interior lamp with substitute bulb
Damage or erratic operation could result.
Cautions