Instructions User guide

27
Tools, Offset & Mainte-
nance Screen Selector
Main “TOOLS, OFFSETS &
MAINTENANCE” Screen
Permanent File Save
Screen Selector
• Stores up to 25 drill files and settings at one
time. Back up your custom drill files in this
screen. If files have not been saved to the
permanent memory and LCD failure does oc-
cur, all custom settings and files will be lost.
WARNING: Permanent memory will hold up
to 25 files at one time; to save more than
25, you must off load saved files to your PC.
If you save 25 new files into permanent
memory and have not saved or off loaded
the previous 25 to your PC, the old files will
be overwritten.
Permanent Memory Save Screen
Permanent Memory File Save Button
• To back up all files and settings saved
under Temporary Memory, touch the
“SAVE” button . Any custom files or settings
changed in temporary memory will be over-
written and permanently stored.
Permanent Memory File Restoration
Button
• Restore and retrieve the last 25 files and
settings saved in Permanent Memory. To
restore files touch the “PERMANENT
MEMORY FILE RESTORATION” button .
The files will be loaded into your File
SAVE/OPEN screen located on the Main
set-up screen.
Setting Method of Measurement Incre-
ments, Inches or Metric.
• Use the Save Button to set the method of
measurement default for your XPS-16 sharp-
ener. Whichever mode the machine is in at the
time of saving will become the start up de-
fault.
Privacy Code Key
• Inaccessible to customer, for factory use only.
Down Load Screen
Selector
• Select this screen for in system programming
and down load capabilities. As upgrades and
optional custom point styles become available,
your machine is equipped to receive these files
from our factory to yours. To utilize each of
the following screens you will need:
nected from PC to XPS-16
2. PC located close to XPS-16
3. Darex Sloader program must be used to trans-
fer software upgrades and download files. For
detailed instructions refer to information on
Touch Screen Details
Facet Overlap Ad-
justment See Adden-
dum for details
Out of Limit Recovery
See Addendum
for details
page 41 & 42
1. Serial port converter with USB cable con-