Safety Instructions

We want you listening for a lifetime.
Selecting fine audio equipment such as the unit you've just purchased is only
the start of your musical enjoyment. Now it's time to consider how you can
maximize the fun and excitement your equipment offers. This manufacturer
and the Electronic Industries Association's Consumer Electronics Group want
you to get the most out of your equipment by playing it at a safe level. One that
lets the sound come through loud and clear without annoying blaring or
distortion and, most importantly, without affecting your sensitive hearing.
Sound can be deceiving. Over time your hearing comfort level adapts to
higher volumes of sound. So what sounds normal can actually be loud and
harmful to your hearing.
We recommend you to avoid prolonged exposure to excessive noise.
Guard against this by setting your equipment at a safe level BEFORE your
hearing adapts.
To establish a safe level:-
Start your volume control at a low setting.
Slowly increase the sound until you can hear it comfortably and clearly,
and without distortion.
Once you have established a comfortable sound level:-
Set the dial and leave it there.
Taking a minute to do this now will help to prevent hearing damage or loss
in the future. After all, we want you listening for a lifetime.
2. Feature:
Small volume and lightweight;
Special manufacturing crafts;
Elegant and aesthetic appearance;
Suit to appreciating and performance at the living room or other elegant
environment.
7. When no planning to use this unit for long periods of time. (i.e. vacation.
Etc.,) disconnect the AC power plug from the wall outlet.
8. Be sure to read the Troubleshooting section on common operating
errors before concluding that your unit is faulty
Connect firmly and securely, make sure that both the audio components
and amplifier are properly ground. Always turn off the power switches
of both units when connecting or disconnecting the power and amplifier.
b) Connecting Speakers:
Connect a SPEAKERS system having an impedance of 4ohms to 8ohms
provided on the rear panel. Please connect the SPEAKERS terminals to
your speaker with wire of the proper gauge, cut as short as possible. If the
connections are faulty, no sound will be heard from the speakers. Make sure
that the polarity (+ & -) of the speaker wires is correct. The right and left
speakers are connected to right and left terminals. Otherwise unnatural
sound with poor bass response will be produced.
Use speakers with the specified impedance shown on the rear of this unit.
Banana Plug connections are also possible. Simply insert the Banana Plug
connector into the corresponding terminal.
*When connecting Banana Plugs to this unit's SPEAKERS terminals,
be sure to tighten the terminal knobs to make contact securely before
connections.
Caution:
When inserting the stripped ends of the speaker wires as shown above,
make sure at least 1/16 inch (1.6mm) of insulation is inside the wire
holders (i.e. no exposed wire is visible) and no loose conductor wire stands
are protruding after connection. If wires touch each other or they touch the
metal parts of this unit, this unit and/or speakers could be damaged. To prevent
speaker wires from coming loose, make sure wire holders are firmly
screwed in.
c.) Connecting the power supply
After making sure the power switch is off, plug the AC power cord into a
wall socket of the CORRECT voltage. When travailing, or otherwise not
using the unit for extended periods of time, it is recommended that you
unplug the cord from the AC outlet.
B. How to use:
1) Please connect the speaker and audio components as per the introduction
above before switch ON the power. Make sure the voltage of power outlet
suit to the unit and all connections is correct;
7
4