Owner Manual

Place the Barstool on a Level Surface to see if it wobbles.
If it wobbles, lift the Stool to some 30cm to 50cm height from the ground.
Keep your feet and toes well away from the drop zone.
Drop the chair freely and vertically with the four legs, hitting the ground, at the same time.
This Drop Test will help to ensure that all the Bolts, Screws and gaps all reach full alignment
status.
Test again for evenness on a Level Surface.
If no wobbles are found, proceed to tighten all the Bolts and Screws.
Note: When tightening the Bolts or Screws, tighten sequentially. Do not tighten any Bolt or
Screw fully and then move towards the next one. This could cause the frame to warp.
If there are still wobbles, loosen the Bolts and Screws and execute this same drop test.
Note: If the Stool is not stable, it could lead to damage to the product.
Place the Seat Base Cover back as shown in picture.
Smooth down with your hand on the Magic Tape on all 4 sides at the edge of the seat.
Make sure all parts are connected and securely locked into position.
Then turn it the right side up.
Your Bar Stool is ready for use.
This Bar Stool can only be used on a flat, level surface.
Step 8
Step 7
Page 8 OF 9