ASSEMBLY INSTRUCTIONS Thank you for purchasing this malignity product . Be sure te check all packaging material carefully for small parts that may have come loose Inside the carton during shipment .
ASSEMBLY INSTRUCTIONS Grab hardware bag from underneath the cushion seat. Do not fully tighten bolts until the Product is level and the assembly of the product is completed. Fig.1 Step 1: Lay the Backrest (A) on a flat soft surface, And Remove the Velcro (H) from under the Cushion Seat (B) Use Short Bolt (2), Spring Washer (4), Flat Washer (5) and Allen Key (1) to attached the seat Cushion Seat (B) to Backrest (A) as shown in Fig. 1.
ASSEMBLY INSTRUCTIONS Step 3: show non Fig.3 Side Stretcher (E) into Backrest (A). side stretcher (E) into Front Leg (C). insertions Front leg (C) into Cushion Seat (B). 3.4Use Short Bolt (2), Spring Washer (4), Flat Washer (5) and tighten with Allen Key (1) to attach Front Leg (C) to Cushion Seat (B). Do Not Fully Tighten Bolts Yet Step 4. Repeat step 3 to attach the remaining Side Stretcher (F) and Front Leg (D) to Cushion Seat (B) as shown on Fig.4 .
ASSEMBLY INSTRUCTIONS o All stretchers shown on Fig. 6 Insert Center Stretcher (G) Between side stretchers (E & F) Step 6 : Insert Wood Screw (6) to fasten as shown in Fig 5.
ASSEMBLY INSTRUCTIONS Step 9: Place the loosely assembled chair on a hard flat surface and apply gentle downward pressure on the seat. As shown on Fig.7. Once the chair is balanced and leveled, fully tighten all bolts. Step 10: Attache Velcro (H) under Cushion Seat (B) as shown in Fig.
