Installation & Assembly

ManualsBrandsDarby Home Co Manuals5 Piece Kitchen & Dining Room SetsBeesley Dining Set

RECTANGULAR DINING TABLE TOP WITH BUTTERFLY LEAF

- 1 -

ASSEMBLY INSTRUCTIONS

Description:

RECTANGULAR DINING TABLE TOP WITH BUTTERFLY LEAF

Dimension : 40”Wx60”/78”Lx30”H

Cube size :62.5”x42”x6.3” NW : 96.8 LBS

(Top) GW :105.6 LBS

Cube size :24.9”x18.5”x7.4” NW : 26.4 LBS

(Pedestal) GW : 30.8 LBS

Summary of content (5 pages)

PAGE 1
ASSEMBLY INSTRUCTIONS Description: RECTANGULAR DINING TABLE TOP WITH BUTTERFLY LEAF Dimension : 40”Wx60”/78”Lx30”H Cube size :62.5”x42”x6.3” NW : 96.8 LBS (Top) GW :105.6 LBS Cube size :24.9”x18.5”x7.4” (Pedestal) NW : 26.4 LBS GW : 30.
PAGE 2
BEFORE ASSEMBLY Thank you for purchasing this quality product. This product has been designed for easy assembly and constructed for durability. Please take the time to read and follow the assembly instructions carefully. Be sure to check all packing material carefully for small parts which may have come loose inside the carton during shipment. Please separate, identify, and count all parts and metal hardware. Compare with part list to be sure all parts are present.
PAGE 3
STEP 1 Attach crossbar (D) and legs (C) to pedestals (B) with nuts (1), washers (2) and (3) as shown below. Tighten with wrench (4). STEP 2 Use the Allen key (5) to loosen the bolts and washer and take of the mounting plate underneath of the table top (A).
PAGE 4
STEP 3 Put the plates on top of the pedestals (B) with Bolts (6), washers (7) and (8) as shown below. Tighten with Allen key (5). STEP 4 Carefully put the base (from Step 3) on the bottom side of top (A). Attach mounting plates to top (A) with bolts and washers from Step 2. Tighten with Allen key (5).
PAGE 5
STEP 5 Unlatch 2 end pieces of table top by the latches underneath table top. Pull the 2 ends of the table top apart. STEP 6 Unfold the butterfly leaf with the apron at both ends straightened up as shown on the Step 6. Place flattened butterfly leaf at the center of the table. Then push two end pieces inward making sure all pins & holes aligned.