User manual

Installing and Configuring

Your NI 6034E/6035E/6036E

This chapter explains how to install and configure your

NI 6034E/6035E/6036E device.

Installing Your Software

Complete the following steps in order to install your software before

installing your NI 6034E/6035E/6036E device.

1. Install your ADE, such as LabVIEW or Measurement Studio,

according to the instructions on the CD and the release notes.

2. Install NI-DAQ according to the instructions on the CD.

Note

It is important to install NI-DAQ before installing your NI 6034E/6035E/6036E

device to ensure that the device is properly detected.

Installing Your Hardware

Your NI 6034E/6035E/6036E device fits in any 5 V expansion slot in your

computer. However, to achieve best noise performance, leave as much

room as possible between your NI 6034E/6035E/6036E and other devices.

The following are general installation instructions, but consult your

computer user manual or technical reference manual for specific

instructions and warnings.

Note

Follow the guidelines in your computer documentation for installing plug-in

hardware.

♦ PCI-6034E/6035E/6036E

1. Turn off and unplug your computer.

2. Remove the cover.

3. Make sure there are no lighted LEDs on your motherboard. If any

are lit, wait until they go out before continuing your installation.

UM.book Page 1 Monday, May 14, 2001 10:32 AM