User manual

Index
NI 6034E/6035E/6036E User Manual I-4 ni.com
GPCTR1_SOURCE signal, 4-37
GPCTR1_UP_DOWN signal, 4-39 to 4-41
ground-referenced signal sources
description, 4-7
differential connections, 4-12
single-ended connections (NRSE
configuration), 4-16 to 4-17
H
hardware
configuration, 2-3
installation, 2-1 to 2-3
hardware overview
analog input
input mode, 3-2
scanning multiple channels,
3-3to3-4
analog output, 3-4
block diagram, 3-1
digital I/O, 3-4 to 3-5
timing signal routing
device and RTSI clocks, 3-6 to 3-7
programmable function inputs, 3-6
RTSI triggers, 3-7 to 3-8
I
input mode. See analog input modes.
input range
exceeding common-mode input ranges
(caution), 4-8
measurement precision (table), 3-3
overview, 3-3
installation
common questions, C-2
hardware, 2-1 to 2-3
software, 2-1
unpacking 6025E devices, 1-6
I/O connectors
exceeding maximum ratings
(caution), 4-1
optional connectors
50-pin E series connector pin
assignments (figure), B-3
68-pin E series connector pin
assignments (figure), B-2
pin assignments (figure), 4-2
signal descriptions (table), 4-3 to 4-5
signal summary (table), 4-5 to 4-6
L
LabVIEW application software, 1-5
M
manual. See documentation.
Measurement Studio software, 1-5
multiple channel scanning, 3-3 to 3-4
N
NI 6034E/6035E/6036E devices
See also hardware overview.
block diagram, 3-1
common questions about, C-1 to C-5
features, 1-1 to 1-2
optional equipment, 1-5 to 1-6
requirements for getting started, 1-3
safety information, 1-6 to 1-7
software programming choices
National Instruments ADE
software, 1-5
NI-DAQ driver software, 1-4 to 1-5
unpacking, 1-6
using PXI with CompactPCI, 1-2 to 1-3
NI Developer Zone, D-1
UM.book Page 4 Monday, May 14, 2001 10:32 AM