Product guide

8
Control Modes
There are 2 ways to control the fazer: 1) Wireless remote control (stand-alone)
2) DMX512 (1 Channel)
Wireless remote control
1. You can use the Atmos F-350 with a wireless remote control.
2. Be sure to plug the receiver into the connector (6) on the backside of the fazer.
3. Just press one of the two buttons to start fogging, both buttons have the same function.
Multiple Atmos fazers (DMX Control)
1. Fasten the effect light onto firm trussing Leave at least 1 meter on all sides for air circulation.
2. Always use a safety cable (ordercode 70140 / 70141).
3. Use a 3-p XLR cable to connect the Atmos fazers and other devices.
4. Link the units as shown in (figure 3), Connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.
5. Supply electric power: Plug electric mains power cords into each unit's IEC socket, then plug the
other end of the mains power cord into proper electric power supply sockets, starting with the first unit.
Do not supply power before the whole system is set up and connected properly.
Multiple Atmos fazers DMX Set Up
Fig. 3
Note : Link all cables and set dip switches before connecting electric power