Product guide

Multiple Cameleon Bars (Master/Slave control)

1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.

2. Use a 3-p XLR cable to connect the Cameleon Bar.

The pins:

1. Earth

2. Signal -

3. Signal +

3. Link the units as shown in (Fig. 3), Connect a DMX signal cable from the first unit's DMX "out"

socket to the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.

You can use the same functions on the master device as described on page 12 (Built-in Programs or

Autorun). This means on the master device you can set your desired operation Mode

and all slave devices will react the same as the master device.

Multiple Cameleon Bars (Master/Slave control)

Fig. 3

Multiple Cameleon Bars (DMX Control)

1. Plug the end of the electric mains power cord into a proper electric power supply socket.

2. Use a 3-p XLR cable to connect the Messengers.

3. Link the units as shown in (figure 4), Connect a DMX signal cable from the first unit's DMX "out" socket to

the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.

4. Supply electric power: Plug the end of the mains power cord into proper electric power supply sockets.

Do so for all units and the controller.

Multiple Cameleon Bars Set Up

Max. 30 Cameleons

Fig. 4

Note : Link all DMX cables before connecting electric power

5. Do not supply power before the whole system is set up and connected properly.

Design your show according to your DMX controller functions. See page 12 for more about DMX

programming.