User`s manual

DAP Technologies B-7
Regulatory Information
CE Notice (European Union)
This device has been tested and found to conform with the limits set for a Class
B product.
• EN 55022 — “Limits and Methods of Measurement of Radio Interference
Characteristics of Information Technology Equipment”
• EN 55024 — “Information technology equipment - Immunity characteristics -
Limits and methods of measurement”
• EN 61000-3-2 — “Electromagnetic compatibility (EMC) - Part 3: Limits -
Section 2”
• EN 61000-3-3 — “Electromagnetic compatibility (EMC) - Part 3: Limits -
Section 3”
• EN 60950 — “Safety of Information Technology Equipment.”
• EN 55022 Emissions requirements
RF Exposure Information (SAR)
This device is compliance with SAR for general population /uncontrolled
exposure limits in ANSI/IEEE C95.1-1999 and had been tested in accordance
with the measurement methods and procedures specied in OET Bulletin 65
Supplement C.
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This device was tested for operations with the device
contacted directly to the human body to the back side of the EUT. To maintain
compliance with FCC RF exposure compliance requirements, avoid direct
contact to the transmitted antenna during transmitting.
IC Regulations
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may
cause undesired operation of the device.