Product guide

13
38. Microphone volume control
Use to adjust the volume of the microphone channel.
39. Headphones output
You can connect a pair of headphones with a minimum impedance of 32 Ohm to this stereo TRS ¼”jack.
The jack should be wired as tip=left, ring=right and sleeve=ground
Back Functions
40. USB connector
To connect your Core Kontrol D1to a PC / laptop/ Mac.
41. Master TRS jack out L/R
Use these outputs to connect an amplifier/mixer with balanced inputs.
42. Master RCA out L/R
Use these outputs to connect an amplifier/mixer with unbalanced inputs.
43. Touch sensitivity trimmer A/B
Use these trimmers to adjust the touch sensitivity of the jogwheel.
Operations
Selecting Folders
• Make sure you’re in the file system/ folder structure panel (see page 22). Hold the shift (29) button and
push the load A/back (27) button to return to the file system/ folder structure panel if you are in the
file/ search results panel. Dial the track select (35) encoder to browse the folders.
• Push the track select (35) encoder to open the desired folder. Now you’re in the file/ search results
panel and are ready to select a track as described before.
• Push the load A/back (27) button to return to the file system/folder structure panel.
Selecting tracks using the track select encoder
• Make sure you have opened the desired folder as described in Selecting folders and that you are in
the file/ search results panel (see page 22)
• Dial the track select (35) encoder to browse the tracks.
• Push the load A/back (27) button or the load B/view (36) button to load the track in respectively deck
1 or deck 2.
Starting Playback
• Push the play/smart play (21) button during the pause mode or cue mode to start playback, the LED
in the play/smart play (21) button lights up.
Stop Playback
There are two ways to stop playback:
• Push the play/smart play (21) button during playback to pause at that point.
• Push the cue/smart cue (8) button during playback to return to the cue point and enter pause
condition.
Pausing
• Push the play/smart play (21) button to pause playback.
• The play/smart play (21) button blinks when the pause mode is set.
• Playback resumes when the play/smart play (21) button is pushed again.
Setting a Cue Point
• Push the play/smart play (21) button to pause playback.
• The play/smart play (21) indicator flashes as the deck is in pause mode.
• Dial the jogwheel (7) to go to the desired cue point.
• Push the cue/smart cue (8) button and your cue point will be stored. The cue point will be indicated in
the waveform display as shown in figure 6 on page 14.
• Push the play/smart play (21) button to continue playback.