Product guide

11
11. Parameter 1control
The Parameter 1 and 2 controls allow you to adjust effect parameters. Note that not all effects require
two parameter controls.
12. Parameter 2/key control
The Parameter 1 and 2 controls allow you to adjust effect parameters. Note that not all effects require
two parameter controls.
While holding the shift (29) button, this control allows you change the key of the song while the tempo
remains unchanged.
13. Effects select encoder
Tapping this button allows you to select one of the available effects in forward direction. The included
Virtual DJ LE software gives you access to seven effects as shown below.
14. Samples button
Pushing this button toggles the sampler mode on or off. The button will light up to indicate sampler mode
is active while the “sampler panels” (see page 22).
15. Hotcue/sample 3 button
The Core Kontrol D1allows you to store up to four hot cue points per deck. See page 14: “Setting a hot
cue point in pause mode” and “Setting a hot cue point in play mode”.
In sampler mode:
While holding the shift (29) button pushing this button allows you to start/stop recording the
corresponding sample.
Pushing this button allows you to start/ stop sample playback for the corresponding sample.
16. Hotcue/sample 4 button
The Core Kontrol D1allows you to store up to four hot cue points per deck. See page 14: “Setting a hot
cue point in pause mode” and “Setting a hot cue point in play mode”.
In sampler mode:
While holding the shift (29) button pushing this button allows you to start/stop recording the
corresponding sample.
Pushing this button allows you to start/ stop sample playback for the corresponding sample.
17. x2/shift button
Allows you to multiply the loop length by 2.
While pushing and holding the shift (29) button, tapping this button allows you to shift the loop with 1
beat.
18. Out/reloop button
This button allows you to set the endpoint of the loop or to exit loop playback.
While pushing and holding the shift (29) button, pushing this button allows you to reloop.
19. Keylock/pitch button
Tapping this button allows you to toggle the keylock mode on or off. In keylock mode, the pitch fader
allows you to Change the tempo of the song played back while the key of the song stays unchanged.
While holding the shift (29) button, tapping this button allows you to select the maximum range for the
pitch control fader.
20. Scratch/crossfader curve button
This button allows you to select or deselect scratch mode for the jogwheel. While not in scratch mode,
the jogwheel is in jog mode.
Pushing this button while holding the shift (29) button allows you to change the crossfader curve.
21. Play/smart play button
This button allows you to toggle between pause mode and playback mode.
Mixer Functions
22. Channel gain
The gain control allows you to adjust the input-sensitivity for a channel and thus optimally matching the
incoming signals to the mixer’s internal operation level.