User manual

IMIX 5.3

Ordercode: D2352

9. Input selection switch (channel 1/2)

With this you are able to assign the line inputs or the

phono inputs to the according channel.

10. Peak LED

The peak LED shows peak levels in a channel’s

incoming signal level. If the red peak LED frequently

blinks or constantly lights, the corresponding

channel is likely to enter clipping and you have to

reduce the input’s amplification using the gain (8)

control. The peak LED lights at a level of 8 dB below

clipping. Make sure that the peak LED lights only

briefly during dynamic peaks.

11. Input selection switch (channel 3/4)

With this you are able to assign two sets of line inputs

to the according channel.

12. Zone assign buttons

Use these 3 buttons to assign the corresponding

channel to one or more zones.

13. Channel fader

A logarithmic 50mm fader, which controls the

volume of the corresponding channel. The overall

volume is set with the master control.

14/15/16. Equalizer section (zone A/B/C)

The zone equalizer section allows

shaping of the outgoing audio signal. All

input channels are fitted with 3-band

EQ. The high (15) and low (16) shelving

controls have their frequencies fixed at

10 KHz and 100 Hz respectively. The mid

(14) range control has a peaking

response frequency at 1 KHz. All 3 bands

have up to 12dB cut and boost, with a

centre detent for. Turning the equalizer

control to the right amplifies the

frequency range; turning to the left

attenuates the signal. Minor changes to

an equalizer control usually produce the

best results. Try to avoid excessive

enhancement of the mid band.