Product guide

13
Program play
1. Push the play/pause (24) button to enter pause mode.
2. Push the progr. (9) button, the player will enter program mode, indicated by PG blinking in the LCD
(13) display.
3. Select the desired track by pushing the track/trim (19) or track/trim (20) buttons. The
selected track will be added to the program sequence.
4. Push the progr. (5) button to store actual track in the program sequence.
5. Repeat step 3 and 4. A maximum of 99 tracks can be programmed.
6. Use the play/pause (24) button to start/pause program play.
7. To exit program play, pause playback by pushing the play/pause (24) button and push and hold the
progr. (5) button more than 2 seconds.
• To erase a program, push and hold the progr. (5) button more than 2 seconds while in program mode.
Loop play
1. Push the loop in (16) button to set the loop start point, the LED in the button will light up, indicating
that the start point is memorized.
2. Push the loop out (17) button to set the loop end point. The LED in the button will light up. After the
end point is set; the playback will enter the loop play from start point to end point repeatedly. Both the
loop in (16) and loop out (17) button’s LEDs will blink and RELOOP will appear in the LCD display.
3. Pushing the reloop/exit (18) button will cancel the loop play function, the RELOOP indication in the
LCD display (13) will disappear and the loop in (16) and loop out (17) button will stop blinking.
Set auto loop length
1. Push and hold the rec/auto (5) button while dialing the jogwheel (14). The LED in the button will
light up and the display will show AUTO. Use the jogwheel to setup the number of bars you plan to
record for the auto loop. The range is 1/32 to 32 (32/1) bars. Default the loop length is 2/1.
Auto loop play
1. Push the rec/auto (5) button. The LED in the button will light up.
2. Push the loop in (16) button to set the loop start point, Both the loop in (16), loop out (17) and
reloop/exit (18) buttons will start blinking and RELOOP will appear in the LCD display indicating that the
auto loop playback is active.
3. Pushing the reloop/exit (18) button will cancel the loop play function, the RELOOP indicator in the
LCD display will disappear and the loop in (16) and loop out (17) button will stop blinking.
Note: 1/1 equals one bar or 4 beats. When auto loop playback starts, the loop length is still editable by
dialing the jogwheel (14) while pushing and holding the rec/auto (5) button, push the loop in (16) button
after readjusting the loop length.
Reloop
1. If you press the reloop/exit (18) button, the disc will return to the last selected loop.
2. Push the loop in (16) button over and over rapidly to start the loop again and again.
3. Push the reloop/exit (18) button again, the loop play function is canceled, the LOOP indicator dims.
Relay play (two CD players)
1. Activate the relay play mode by pushing the relay (12) button. The button’s LED will light up.
2. Start playback on the first player.
3. When the current track ends, the standby player will start playback automatically.
4. The first player will enter pause mode at the start of the next track on its disc.
• By repeating this operation, the two players can be used to perform continuous relay play.
• By loading new discs and choosing desired tracks on the player in standby, a continuous program
of selected tracks can be played.
• By setting a cue point on the standby player, a relay of any desired cue point of the selected track
can be performed.