Use and Care Manual

PHENOMENAL BRANDS, Phenopatch Products

a division of DAP Products Inc.

2400 Boston Street, Suite 200, Baltimore, Maryland 21224

Phone: 410-675-2100

Revised: 11/14/13

DAP

PHENOPATCH

Premium Lightweight Joint Compound

with DRYDEX

Dry Time Indicator Technology

 Produces 50% less airborne dust when sanded than heavyweight joint compounds for less mess and

faster cleanup

 For the ultra-smooth finishing of interior gypsum panel joints

 Goes on PINK, dries WHITE when it’s time to reapply or finish

 De-aired to eliminate pin-hole bubbles

 Ready-to-use

 Interior use

Packaging: 1 Gallon (3.87 L)

Color: Goes on pink and dries white

UPC Numbers: 0 70798 10225

Company Identification:

Manufacturer: PHENOMENAL BRANDS, Phenopatch Products, a division of DAP Products Inc., 2400

Boston St., Baltimore, Maryland 21224

Usage Information: Call 1-888-327-8477 or visit dap.com and click on “Ask the Expert”

Order Information: 1-800-327-3339

Fax Number: 410-558-1068

Also, visit the Phenopatch website at www.phenopatch.com.

Product Description:

DAP

PHENOPATCH

Premium Lightweight Wallboard Joint Compound with DRYDEX

Dry Time

Indicator Technology is a pre-mixed joint compound for the ultra smooth, high quality finishing of gypsum

panel joints, nail heads and metal corner beads. The unique DRYDEX

Dry Time Indicator goes on PINK and

dries WHITE indicating when additional coats can be applied or when it’s read for finishing. De-aired formula

eliminates the formation of pinhole bubbles for an ultra smooth finish. Also, it sands effortlessly and produces

50% less airborne dust than other heavyweight joint compounds, which means less mess and faster clean-up.

The lightweight formulation means less shrinkage, so fewer coats are required than with other joint compounds.

It works faster with less effort and weighs up to 25% less than conventional compounds for easier handling.

Interior use only.

Suggested Uses:

For the smooth, high-quality finishing of interior gypsum panel joints, nail heads and metal corner

beads.

PAGE 1
PHENOMENAL BRANDS, Phenopatch Products a division of DAP Products Inc.
PAGE 2
Surface Preparation & Application: 1. Prepare surface by recessing nails or screws into panels 1/32”. 2. Fill the space between panels with joint compound. Center wallboard joint tape over joint and press into fresh compound with a 5” or 6” application knife. Remove excess joint compound and cover embedded tape with a thin layer of compound. Apply compound to all nail heads and spread smooth with long strokes parallel to joint.
PAGE 3
MSDS No.: 00079946005 Clean Up & Storage: Wash tools immediately after use with soapy water. Dried material will have to be cut or scraped away. Be sure container is closed and tightly sealed. Store in a cool, dry place. Safety: WARNING! IRRITANT. May be harmful if inhaled. May cause eye, skin and respiratory irritation. Harmful if swallowed or absorbed through the skin. Do not breathe vapors or dust. Use only with adequate ventilation.