TDS

08/2018 | www.dap.com
• Do not apply when temperatures are below 50°F.
• Do not apply outside if rain is expected within 24 hours.
• Do not use on floors or as a caulk, sealant or joint filler over cracks and joints where expansion and
contraction
may occur.
• DO NOT USE AS A SKIM COAT.
• For exterior applications, always topcoat with a good quality exterior grade paint.
• If a textured finish is desired, add clean sand to spackling compound prior to application.
• Do not use for tuck pointing applications on brick
• For larger areas to be patched on bare concrete, use a latex fortified Portland cement-based dry mix.
1. Surface must be clean, dry and free of foreign material.
2. Stir thoroughly before use.
(When using the 5.5 oz squeeze tube, knead tube prior to use. Remove cap and cut nozzle to desired
opening size.)
3. Apply with a clean putty knife.
4. One application is usually sufficient for small repairs.
For repairs deeper than 1/8”, apply two or more layers allowing spackling to dry between applications.
5. For a smoother finish, dip putty knife in water and lightly smooth spackling.
6. Spackling will change color to white when surface can accept a second application or is ready to be
painted or sanded in 1 to 5 hours.
Wet sanding is recommended to avoid generation of dust.
7. Clean tools immediately with water.
NOTE: To retain the effectiveness of the dry time indicator, keep the container tightly closed after use.
Consistency
Paste
Vehicle
Latex Polymer
Volatile
Water
Filler
Inert Filler
Odor
Mild
FOR BEST RESULTS
APPLICATION
TYPICAL PHYSICAL & CHEMICAL PROPERTIES