TDS

02/21/2021
Product Application
1. Cut nozzle at a 45° angle to desired bead size.
2. Puncture inner foil seal.
3. Load cartridge into caulk gun.
4. Fill gap with sealant. Using steady pressure, apply consistent 3/16" bead size for optimal joint
protection.
5. If necessary, tool or smooth the bead of sealant with a finishing tool before the sealant skins over.
6. Allow sealant to cure for at least 30 minutes before exposing to water or paint. Sealant surface may still
be tacky. Sealant reaches full cure in 24 hours.
7. Clean up excess uncured sealant from surface and tools with mineral spirits. Scrape or cut away excess
cured sealant. Do not use mineral spirits or any other solvent to clean hands or skin. Wash hands or
skin with soap and water.
8. Paintable in 30 minutes. Use only high quality acrylic latex coatings. 30 minute performance achievable
with 3/16” maximum diameter bead, temperature at 73°F minimum & 50% relative humidity.
9. Reseal cartridge for storage and reuse. Store below 80°F in dry place for optimal shelf life.
Typical Uncured Physical Properties
Appearance/Consistency
Gunnable, non-sag paste
Base Polymer
Advanced hybrid polymer
Filler
None
Volatile
Not applicable
Weight % Solids
>98%
Density (lbs per gallon)
8.6
Odor
Very mild
Flash Point
>212 ºF
Freeze Thaw Stability (ASTM C1183)
Will not freeze
Shelf Life
12 months
Coverage
49 linear feet at 3/16” diameter bead
Typical Application Properties
Application Temperature Range
0ºF to 140ºF
Tooling Time (Working Time)
20 minutes
Tack Free Time
2 hours
Full Cure
24 hours
Return to Service Time
30 minutes
Vertical Sag (ASTM D2202)
0.15”
TYPICAL PHYSICAL & CHEMICAL PROPERTIES