User's Guide

And we have CE8000B series which includes CE8640B (half VGA screen), CE8810B
(full VGA screen) and CE8820B (wide VGA screen)
CE8640B
CE8810B & CE8820B
A very important note is that all these products all have the same electronic design (same
processor, FPGA, memory,…), so same design but different form factor to fit in our
existing casings.
The same OEM module will be used in all products with same antennas that are located
on mainboards (PCB mounted).
The electrical interface between OEM module and our mainboards is the same and the
physical interface is a board-to-board connector.
OEM 802.11bg/BT Combo Module
Changes or modifications not expressly approved by DAP Technologies could void the
user's authority to operate the equipment.
In order to comply with the FCC RF exposure requirements this module must be installed
in specific host configurations as defined in this document. For CE8000B series the
antennas are installed on the main board with a least 2.5 cm spacing from the antennas to
the bottom of the enclosure. The CE3000B and CE5000B series are hand held with the
antennas installed on a piggyback board that is located below the LCD display. There is
not provision for simultaneous transmission of BT and 802.11b/g. The end user manual
for all final host configurations must include the following warning statement. In order to