Owner's manual

8
CDR-110MKIV
Ordercode: D1259
10, 30) Eject :
Press this button to eject the CD.
11) Rec level VU meter:
Allows you to monitor the Aux in (23) input to record without distortion by using the Rec input vol (21)
control.
12) SD MMC card:
Use this port to connect your SD/MMS card for playback/recording.
13) LCD:
When powering on the CDR-110 without a USB stick or a SD/MMC card inserted, the CDR-110 will start
searching for a source, indicated by “USB” blinking in the display. If the CDR-110 does not detect a
source within approximately 6 seconds, the display will show “No USB.” If you insert a USB stick or a SD/
MMC card, the display will look as shown in fig. 04.
Fig. 04
Showing the total number of folders and the total number of tracks (total of all tracks in all folders).
14) USB:
Use this port to connect your USB stick for playback/recording.
15, 29) Find:
Press the Find button once to start track search, twice for folder search. Pressing the button again will exit
find mode. See 1. Play Modes on page 9 for more info.
16, 27) Folder :
Press this button to skip to the previous folder’s first track.
17, 26 ) Folder :
Press this button to skip to the next folder’s first track.
18, 28) Repeat:
Use this button to repeat one track, one folder or all tracks of the medium. See 6. Using the find function
on page 10 for more info.
19, 43, 44) Rec/Del:
Pressing these buttons activates the recording/deleting mode. See 10. Recording, page 11. Pressing and
holding this button down for 3 seconds enables you to delete a track from either the USB-stick or the
SD/MMC-card. See 11. Delete a track, page 12.
20, 41) Func(t):
Press this button to select between CD, USB, SD/MMC-Card or AUX as recording source.
21) Rec input vol:
Use this control to adjust the level of the Aux in (23) input. Make sure the red LED of the Rec level (11) VU
meter does not light and that the orange LED only lights up occasionally.
22) Line out:
Connect to the line input of the Mixer.