Operation Manual

15
Fig. 14
59. Channel 1 CD RCA input
Use to connect a CD player.
60. AC inlet with integrated fuse holder
This connector is meant for the connection of the supplied main cord. Connect one end of the power
cord to the connector, the other end to the mains, then turn on the power switch to operate the unit.
Note: Please make sure that the supply voltage matches the operation voltage before connecting the
unit to mains. Replace the fuse only with a fuse of same specification (T1A).
61. Trim output control
Use this control to match your master out optimally to your amplifier.
Note: If the control is turned completely to the left, there is no output signal.
62. Master XLR balanced out
Use these outputs to connect an amplifier with balanced inputs.
63. GND screw
To connect the ground wire of your turntable.
64. Return input
To connect the (stereo) outputs of your effectprocessor.
65. Send output
To connect the (stereo) inputs of your effectprocessor.
66. USB 2 input
To connect to a PC/Mac with DJ software.
67. USB level control
Use to adjust the level for the USB inputs.
68. USB 1 input
To connect to a PC/Mac with DJ software.
69. GND screw
To connect the ground wire of your turntable.