User manual

8
COM-ART
Ordercode: D1414
Installation
Remove all packing materials from the COM-ART. Check if all foam and plastic padding is removed.
Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Power Supply
The COM-ART can be powered with an AA battery, or with the included USB cable connected to an USB
adapter (5V, 500mA).
Note: The USB power inlet is to power the device not to charge the battery. Please don’t apply USB
power when a battery is inserted. It can cause dangerous situations and will damage both battery and
the device. Any warranty will be expired.
Replace the Battery
01) Press and pull the battery cover to open the battery housing.
02) Insert an AA battery (use good disposable batteries or good rechargeable batteries).
03) Replace the battery cover.
Fig. 03