Installation Guide

Single Handle Tub & Shower Faucet Trim Kit

Mélangeur 3trous pour robinet et douchette de

baignoire à simple poignée

Grifería solo para grifo de ducha y bañera de una manija

Pub No. IM-Kit T&S/12-14

Shown/Mostrado/Illustré

D510044T/ D500044T/ D512044T/ D511044T

PAGE 1
Single Handle Tub & Shower Faucet Trim Kit Mélangeur 3 trous pour robinet et douchette de baignoire à simple poignée Grifería solo para grifo de ducha y bañera de una manija D510044T/ D500044T/ D512044T/ D511044T Shown/Mostrado/Illustré Pub No.
PAGE 2
Shut off the main water supply before installation by turning the valves clockwise.
PAGE 3
A . Installation on 1/2" Copper Pipe(5/8" OD) - B . Threaded Installation with 1/2" Steel or Brass Pipe (7/8" OD): 2.
PAGE 4
Anne collections (where the bonnet nut is visible under the handle) are supplied with 2.4: Install the handle assembly to the valve stem and tighten the set screw located on the bottom of the handle. Install the insert after tightening the set screw to the stem.
PAGE 5
2.4 Remarque : 3. Installing the Showerarm with Trim Ring & Showerhead Apply pipe tape to the threads on both ends of the showerarm. Slide the shower trim ring onto the showerarm and install the shower arm to the elbow located in the wall cavity. Tighten and align this to sit horizontally. Before installing the showerhead, flush the shower piping with water to clear any debris. Install the showerhead and tighten with a wrench.