Installation Guide

ManualsBrandsDanze ManualsBathOpulence Single Handle Pressure Balance Valve with Diverter in Brushed Nickel

Pub No. IM-Kit T&S/04-15

Shown/Mostrado/Illustré

Single Handle Tub & Shower Trim Kit

0pODQJHXU¬WURXVSRXUURELQHWHWGRXFKHWWHGH

EDLJQRLUHjVLPSOHSRLJQpH

*ULIHUtDVRORSDUDJULIRGHGXFKD\EDxHUDGHXQDPDQLMD

Opulence™

D502257T & D512157T

(Tub & Shower)

D500457T (Valve Trim Kit)

Summary of content (5 pages)

PAGE 1
Opulence™ Single Handle Tub & Shower Trim Kit 0pODQJHXU ¬WURXV SRXU URELQHW HW GRXFKHWWH GH EDLJQRLUH j VLPSOH SRLJQpH *ULIHUtD VROR SDUD JULIR GH GXFKD \ EDxHUD GH XQD PDQLMD D502257T & D512157T (Tub & Shower) D500457T (Valve Trim Kit) Shown/Mostrado/Illustré Pub No.
PAGE 2
Danze always recommends that plumbing products be installed by a licensed professional. Danze aconseja siempre que sea un profesional autorizado quien instale los productos de plomería. Danze recommande que les articles de plomberie soient toujours installés par un professionnel qualifié. Shut off the main water supply before installation by turning the valves clockwise.
PAGE 3
A. Installation on 1/2'' Copper Pipe (5/8'' OD) Back out the set screw in the bottom of the spout to allow the spout to slide on the stub-out pipe. Slide the flange and the spout over the pipe with the spout tight to the wall, tighten the set screw to the pipe. (Fig A-1) B.
PAGE 4
3.3 Attach the escutcheon to the valve body using the screws provided. 3.4 Install the handle assembly to the valve stem and tighten the set screw located on the bottom of the handle. Install the insert after tighting the set screw to the stem. NOTE: When installing the handle assembly, rotate the stem clockwise to close the valve. Lever handles should be in the vertical position when the valve is closed. A1 3. Instale el escudo y la llave en la válvula. 3.
PAGE 5
Installer l'écusson et la manette sur le corps du robinet. 3.1 Avant d'installer l'écusson, enlever le capuchon de plastique du protège-plâtre en tournant le capuchon dans le sens des aiguilles d'une montre. 3.2 A. Les valves sont fournies avec un manchon de valve et un écrou de chapeau chromés. Des garnitures de fini assorfi sont fournies pour les modèles Melrose, Antioch, Sheridan, Bannockburn, Aerial, Eastham et Cap Anne (manchon de valve et écrou de chapeau visibles sous la manette).