Service manual

Product description
Overall description
This section describes the overall product and its functionality
The Air Conditioner is designed to control the internal temperature of an outdoor enclosure.
The Air Conditioner removes dissipated heat from electronic equipment and is designed to
maintain correct temperature for electronic equipment.
This manual covers a series of air conditioners. Models available are:
Enclosure
size inch
Cooling
capacity/
btu
Heater
power /watt
Voltage /
frequency
External over
current pro-
tection / A
Minimum supply
cord
dimension
H*W*D
29 -17.3-
11.3
4000 1000
115V/60Hz C20A AWG 14
230V/50-60hz C10A
This table shows the accessories available from supplier
No Description
707585 Air Filter, A/C 4000
707600 Crankcase heater 115V
707601 Crankcase heater 230V
Introduction
Model overview
Available
accessories
Warning
This installation manual and the product use various displays and labels to ensure safe use.
Failure to follow these instructions could result in injury, death or damage to equipment.
Ignoring these displays and labels and incorrectly using the product could have results as
classied below.
Please read the following warning symbol information before reading the rest of this section,
and be sure to strictly observe all instructions.
This product is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the product by a person responsible for
their safety.
Children should be supervised to ensure that they do not play with the product.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualied person in order to avoid a hazard.
Failure to follow these instructions could result in death or serious injury
Failure to follow these instructions could result in injury or property damage.
This symbol means something that should NOT be done
Project safety is your responsibility!
Follow the instructions in this manual regarding the installation method and installation
orientation. All work should be performed by qualied personal using safe work practices.
All proper personal protective equipment should be used. PPE required for this installation
includes, but is not limited to:
• Safety glasses
• Hard hat
• Safety shoes
• Hearing protection
• Cut resistant gloves
• Face shield
• Proper work attire (long sleeve shirt and long pants)
Please strictly observe the following: Special Skill is required to install the Dantherm products.
Non-qualied personnel should not attempt any of the actions shown in this installation
guide. Dantherm shall not be responsible for improper installation or any accidents, damage,
or injury resulting from improper installation.
Introduction
General precaution
Warning
Caution
Warning
Caution
086161 • Version 1.0 • 15.07.2014
5
4
en