ecoCOOLING™ Combo Panel Mounted Air Conditioners by Dantherm Air Handling, Inc. PRODUCT INFORMATION MANUAL Doc Ref: EcoCooling IOM Manual RevA Dantherm Air Handling, Inc 110 Corporate Drive, Suite K Spartanburg, SC 29303 Tel # 864 595 9800 Fax # 864 595 9810 Email Dantherm.usa@dantherm.com Web Site www.dantherm.
ecoCOOLING Combo Installation, Operating & Maintenance Manual Contents 1 GENERAL SAFETY & WARNING INSTRUCTIONS ................................................................... 3 2 UNPACKING, HANDLING & INITIAL INSPECTION.................................................................. 3 3 INSTALLATION ............................................................................................................................... 3 3.1 3.2 4 DESIGN DATA .............................................
ecoCOOLING Combo Installation, Operating & Maintenance Manual 1 GENERAL SAFETY & WARNING INSTRUCTIONS Certain parts of electrical systems are inevitably live or have a high operating temperatures. Observe caution at all times. Failure to observe these conditions and installation instructions can cause injury and damage. The system is to be installed and maintained only by trained and qualified personnel. Do not apply power until all ground connections have been made.
ecoCOOLING Combo Installation, Operating & Maintenance Manual Figure 3.1A: Cut Out Template ~ Units are in millimeters Figure 3.
ecoCOOLING Combo Installation, Operating & Maintenance Manual Top Middle Left Right Mounting Hooks Bottom 3.2 Unit Operation Turn AC and DC Mains power on to unit, evaporator fan (internal circuit) should run immediately. Check for the following: Airflow through evaporator coil Abnormal vibration .
ecoCOOLING Combo Installation, Operating & Maintenance Manual 4 Design Data 4.1 General performance Data Model # 4K Combo 6K Combo 8K Combo BTU/ h ** 4,000 Watts Removal ** 1171 6,000 1757 8,000 2343 Voltage (Air Cond.) Voltage (HEX) Hz Ph Breaker Size (AC) Breaker Size (DC) Approx. Weight (lbs / kg) 230V AC 48V DC 50/60 1 15 Amp 7.
ecoCOOLING Combo Installation, Operating & Maintenance Manual Air Conditioner Control Board (USACG-6) AC Power 230V / 115V AC Switch Compressor Relay Compressor Current Sensor Digital Display Right Button Left Button Alarm Interconnect Heat Exchanger Control Board (USHX2) DC Power Internal Fan Ambient / Internal Temp Sensors Interconnect External Fan Alarm Test Button Doc Ref: EcoCooling IOM Manual RevA Page 7 of 14
ecoCOOLING Combo Installation, Operating & Maintenance Manual 5 5.1 MAINTENANCE Trouble Shooting The air conditioners are designed for trouble free life as long as the ambient filter (if applicable) is maintained in a clean condition. To aid in service definition the service personnel can initially identify probable cause by referring to the following trouble shooting chart. If in doubt contact Dantherm Air Handling Inc. for assistance. Always have the Model #, Serial # available before you call.
ecoCOOLING Combo Installation, Operating & Maintenance Manual 5.2 Evaporator and Condenser Coil Cleaning Periodically the coils should be cleaned. No fixed period for cleaning can be provided due to the varying environments in which the air conditioner may be installed. However once the coils become visibly coated with dust it is recommended that they be cleaned with a brush or compressed air. Both sides of the coils should be inspected regularly. 5.
ecoCOOLING Combo Installation, Operating & Maintenance Manual 5.6 Electrical Schematics 5.6.
ecoCOOLING Combo Installation, Operating & Maintenance Manual 5.6.
ecoCOOLING Combo Installation, Operating & Maintenance Manual 5.7 Preventative Maintenance Schedule Dantherm Air Handling, Inc.
ecoCOOLING Combo Installation, Operating & Maintenance Manual 6 Warranty DANTHERM AIR HANDLING, INC., HEAT EXCHANGER AND AIR CONDITIONING UNITS LIMITED WARRANTY DANTHERM AIR HANDLING, INC.’s (“DANTHERM”) limited warranty extends to the original purchaser only of any DANTHERM Pinnacle heat exchanger and Classic air conditioning unit, and to no other person or entity.
ecoCOOLING Combo Installation, Operating & Maintenance Manual 7 RETURN MATERIAL AUTHORIZATION PROCEDURE In the unlikely event of unit failure the following return procedure shall be adopted. All product returns require a Return Material Authorization number regardless of reason. The customer is required to contact the Quality Department at Dantherm Inc. in Spartanburg, SC at (864) 595 9800 to obtain an RMA number.
