Product Manual

ASSEMBLING & MOUNTING THE CART … CON’T
Step 2 Install Bottom Shelf Assembly:
Models 340—Open Shelf Model 440D—Solid Shelf
 Install the Bottom Shelf (#12) to all four legs.
Using 4 of the 1/4” x #20 x 1/2” screws (A) and your
Screw driver, hand start then secure the screws firmly to the leg
frame.
Note: Ensure the shelf is installed so the flat surface is facing up
 NOW, securely tighten ALL 16 leg screws (A)
Page 8
Part Needed:
ASSEMBLING—HOPPER TO BARREL
Installation Steps
Step 1 Attach Lid Stopper
 Slip the Lid Stopper (17) front lip into the slot provided
Located at the top of the barrel in the middle.
 Using the screw driver, secure the Lid Stopper
to the barrel with one 1/4” - #20 x 1/2” (A) screw.
Take care not to over-tighten.
Hardware Required:
Section One: ASSEMBLY INSTRUCTIONS
Screw 1/4”- 20* 1/2” x 1 (A)
ASSEMBLING—LID STOPPER
Part Needed:
Installation Steps
Hardware Required:
Screw 1/4”- 20* 1/2” x 4 (A)
Step 1
 Begin by slipping the burn put end (15) into the slot provided on the end of
the barrel. Do not slide in all the way.
 Connect the Grill Probe Temperature wires, extruding from the barrel,
to the wire connections coming from the hopper. Slide excess wire
back into the hopper assembly.
 Slide the hopper into the barrel completely.
 Using a screw driver, secure the hopper to the barrel, from the inside of the barrel,
using 4 (four) 1/4” - #20 x 1/2” (A) screws.
Take care not to over-tighten or strip the screws.
15
1. Hopper Assembly
110 Volt