Full Product Manual

7
STEP 1
(Verifying Lift Installation)
Before installing your new Rolling Bridge Jack, verify the
following aspects of the installation of the lift where Rolling
Bridge Jacks are being installed. The aspects of the lift
installation that need to be verified should include, but are
not limited to;
1. LIFT LOCATION / PROPER ALIGNMENT
2. OVERHEAD OBSTRUCTIONS.
3. CORRECT FLOOR COMPOSITION/
REQUIREMENTS.
4. OPERATING TEMPERATURE.
5. INDOOR INSTALLATION ONLY.
6. OPERATION MANUALS ON HAND .
7. OPERATORS PROPERLY TRAINED.
OPERATING TEMPERATURE.
Operate Rolling Bridge Jack only between
temperatures of 41° -104° F.
STEP 2
(Rolling Jack Capacities)
THE MAXIMUM LIFTING CAPACITY OF
THESE JACKS ARE DESCRIBED BELOW
DANGER !
IT IS THE RESPONSIBILITY OF THE OWNER /
INSTALLER OF THIS ROLLING BRIDGE JACK TO
ENSURE THAT THE LIFT UPON WHICH THE ROLLING
BRIDGE JACK IS INSTALLED HAS BEEN PROPERLY
INSTALLED ACCORDING TO THE MANUFACTURER’S
SPECIFICATIONS.
IMPORTANT NOTE!
These instructions must be followed to ensure proper installation and operation of your Rolling
Bridge Jack. Failure to comply with these instructions can result in serious bodily harm and void
product warranty. Manufacturer will assume no liability for loss or damage of any kind, expressed or
implied resulting from improper installation or use of this product.
PLEASE READ ENTIRE MANUAL PRIOR TO INSTALLATION !
t Hex-Key / Allen Wrench Set
tMedium Crescent Wrench
tShop Crane or other heavy lifting device
t Medium Flat Screwdriver
tTape Measure: @ 25 Foot
tAir Fitting (to connect air supply)
TOOLS REQUIRED
MODEL MAX JACK
CAPACITY
MAX VEHICLE WEIGHT
FRONT AXLE
MAX VEHICLE WEIGHT
REAR AXLE
DRJ-6
6,000 Lbs / 2,721 Kgs 6,000 Lbs / 2,721 Kgs 6,000 Lbs / 2,721 Kgs
DANGER !
The AXLE WEIGHT of the vehicle being raised should
not exceed the maximum capacity of the Rolling Bridge
Jack. Consult the vehicle manufacturer for
specifications.
NOTE: An air supply ( 20 CFM (.57 M³/MIN.) AND 100 PSI / 7 BAR MINIMUM ) will be required for operation.